Baby Talker Pro with Beating Heart by Still Moments Nursery

– Remote control does not include batteries  (CR2025)

Using the Voice Box:

• Use the “X” Button on your remote controller, to turn the voice box on/off.
• To adjust the volume, use the “Up & Down Arrows”.
• Use the “Left & Right” arrow buttons to seek previous and next moods.
• The numeric pad can been used to switch between any baby mood.
• For an extended role-play press the “0” button and all baby moods will cycle longer for an extended role-play.

How to use your Heart Beat: 

• Pressing the “#” button will active and de-activate the heart beat.

Built in Baby Sound Moods: All Sounds
The voice box will automatically cycle through 9 different baby moods.
You can also use the forward and backward buttons on the remote, to skip to the next sound.
Baby Moods
1. Babbling +Sneeze
2. Happy Yells Laughing
3. Crying Screaming
4. Feeding Hiccups
5. Playing Blowing Bubbles
6. Yelling Angry Sad
7. Pushing Pooping
8. Cooing Grizzling Tired
9. Sleeping Snoring
0. Extended Role – Play

Built in Baby Sound Moods: Sleeping Sounds  The voice box will automatically cycle through 7 different sleeping stages.
You can also use the forward and backward buttons on the remote, to skip to the next sound.
Sleeping Stage
1. Winding Down to Sleep
2. Settling
3. Dreaming
4. Deep Sleep
5. Stirring
6. Restless
7. Farting / Pooping

How to insert into your Sound Box:

1. Prepare your body by adding on the USB body clip provided – Using the template, cut a hole in the lower back of your body and then insert the male outer part of the USB body clip.
2. Insert your fluffing (polyfil) and weighting sack into the lower part of the body.
3. Then insert your Baby Talker Pro Box into the body on top of the weighting sack and push the cable through the inner USB clip attachment.
4. Add enough fluffing around the voice box module so that it covers the module evenly on all sides, more fluffing is recommended at the back of the voice box, to help push it forward so it can be controlled more easily from the front / chest.
5. You’re now ready to assemble the doll.
6. Screw the inner female and outer male USB clips together with the USB cable going through the clip and out from the back of the body.
7. Now you can simply slip the USB battery pack into the nappy where it wont be felt or seen, and connect your Baby Talker Pro.

Rechargeable Battery Packs:
The Baby Talker Pro includes a small rechargeable USB battery pack & USB charger.

How to recharge your battery pack:

• Using the USB cable provided in your protective box, connect the smaller connector to the battery pack.
• Connect the opposite larger end of the USB cable to any USB wall charger (standard phone style charger) or a powered USB port (a computer/laptop etc..)
• Allow your battery pack to charge for 4-6 HRS.

Important Details:
Installation is required.

This listing is for the Baby Talker Pro Box and a USB Rechargeable battery pack only!!
Body not included

**************
WARNING – Keep batteries out of reach of children.
Product contains a Button or Coin cell battery.
The Battery can cause severe or fatal injuries in 2 hours or less if it is swallowed or placed inside any part of the body.